DRDGold nears completion of project to achieve better recoveries at FWGR

13th September 2021 By: Marleny Arnoldi - Creamer Media Online Writer

NYSE- and JSE-listed DRDGold says a project to convert the Driefontein 2 Plant (DP2) at the Far West Gold Recoveries (FWGR) surface retreatment operation, in Gauteng, to closed-circuit milling, is nearing completion.

The R80-million project will achieve a finer grind and, thereby, improve gold recovery rates, as well as enhance leaching conditions, reduce maintenance costs and increase water storage capacity in the current thickeners.

FWGR MD Kevin Kruger explains in a statement that, prior to its acquisition, DP2 treated 180 000 t a month of waste rock.

Post-acquisition, the plant was converted from closed-circuit hard rock milling to three-stage cyclone milling, in an open-circuit configuration, for the coarser fractions in the slimes reclaimed from the Driefontein 5 dump.

“The open-circuit configuration was used due to the limited thickening capacity of the original circuit, the need for a leach density of about 1.45, and to contain capital expenditure.

“Post commissioning and optimisation of the mill, improved gold recoveries of between 46% and 49% were achieved but fell short of recoveries of more than 50% which had been indicated from laboratory test work,” says Kruger.

As the new, regional plant planned as part of the previously announced second phase of development of FWGR will employ closed-circuit milling, it was decided to close the circuit on the current mill to align the two.

“This will ensure that higher-grade, coarser particles don’t get just a single pass through the mill but multiple passes until fine,” notes Kruger.

The conversion to closed-circuit milling entails replacing the two tertiary cyclones with a cluster of cyclones that will classify the mill discharge, together with the primary and secondary cyclone overflows.

The coarse cluster underflow will report back to the mill and the finer cyclone overflow to a new 45-m-diameter high-rate thickener.

The new thickener is required to adjust the slurry density to 1.45 for treatment in the carbon-in-leach plant.

The company expects to commission the converted plant in November.